 |
|
|
 |
Automatic Water Level Controller Cum Indicator |
 |
|
 |
Off Line and On Line Ups |
 |
|
|
Solar Water Heater |
|
|
|
Solar Lantern |
|
|
|
Servo Voltage Control Stabilizers |
|
|
|
|
Automatic Water Level Controller Cum Indicator |
Automatic water level controller cum indicator saves water and protects motor and reduces electricity bill.
Automatic water level controller cum indicator is an electronic gadget called (Motor Controlled Automatically on the Basis of liquid W.R. to Sump and Overhead Tank). Our Automatic water level controller cum indicator is manufactured under the name – LIAMOCON. LIAMOCON takes the responsibility of a man who switching On/Off the motor. Our Automatic water level controller cum indicator serves 24 hours water supply without letting the overhead tank to become dry.
Features
LIAMOCON switches on the motor if:
- The water in overhead tank falls to prefixed low level i.e., below 75%, 50%, 25% as adjusted
- The sump is full irrespective of any levels in the overhead tank at once when power comes
- Soft touch needed in case we need to switch on the motor irrespective of any level in the overhead tank
- The switch is in manual position
LlAMOCON switches off the motor for the following reasons:
- Liquid reaches maximum level in the overhead tank
- There is a low or high voltage
- Liquid in the sump goes below foot valve or as prefixed low level
- Liquid does not flowing to the overhead tank
- The switch is in off position
- Fuse blown off
Technical Support:
Input voltage: 230 Volts AC 50 Hz
Power consumption: 2.5 Watts (approx.)
Relay contact rating: One N/O potential free contact rated at 10 Amps at 230 Volts
Trip time delay: 65 Sec. in case of priming fault
Working voltage: Motor trips if voltage > 250 or < 160 AC
Power on delay: 45 Seconds even in Voltage Fluctuations
Auto / Manual: Enables operation of motor.
Dimensions (mm): 230 x 150 x 63 (l x B x H) Over all Panel Mounting
Front Facia Of Liamocon
- Shows clear indication of water levels in the overhead tank and sump tank
- Shows voltage variation if any in the left bottom corner, it shows green indicator for normal voltage, higher red light indicates high voltage and lower red light indicates low voltage
- Has an easy operatable AUTO-MANUAL feather switch
- Green indicates AUTO Mode, Orange indicates MANUAL Mode and Red indicates dry running of motor
- Soft touch 'NEED' in case to switch on the motor irrespective of any level in the overhead tank
- Soft touch 'SILENCE' for silencing alarm
- Blinking green light indicates liquid flow to overhead tank
- Red indication with beeping sound for overflowing of water from overhead tank
- Side Leap switch enables to power on arid off Direct on for motor
Gives Alarm:
1. When there is a voltage fluctuation
2. When the motor is dry running due to foot valve blockage or priming fault in motor
3. When water overflows from the overhead tank at 'MANUAL' mode
Applications:
Automatic Water level Controller for Hotels, Factories, Homes Apartments, Commercial Complexes, Drainages, etc., It can be fixed for single phase motor, Single Phase Submersibles, Three Phase motors. (For 3Æ and Single Phase Submersible Starter is necessary) and open well, Bore well and Sump. We can control two motor and two sumps and two overhead tanks by single unit (Auto Change Over). Many models available in different ranges.
|
|
|
|
|
 |